MS3-Pro 2JZGTE plug and play ecu

diyautotune

$1,599.00 

Share:

The state of the art Megasquirt PRO ECU is now a fully featured plug n place ECU for 2jzGTE and 2JZGE engines.  Take advantage of awesome features like traction control, flex fuel, engine protection, and more!

Easy to Use and Install!    

  • Fully Plug and Play Installation - No wiring required for basic functionality.  Average install time is under 1 hour!
  • Base map is pre-loaded to help your engine start on the first turn of the key
  • Real time tuning and data logging with a laptop connection
  • 8 GB internal data logging with built in SD card
  • Supports most aftermarket wideband sensors

Fully Tunable Engine Control!     

  • 16x16 Fuel Tables allow high resolution tuning
  • 16x16 Ignition Tables
  • Multiple Acceleration enrichment strategies
  • Closed Loop Idle Speed Control
  • Air Conditioner Control
  • 6 sequential fuel injector channels with individual trim tables
  • Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
  • Allows removal of stock airflow meter
  • Boost control - supports single turbo or sequential twin turbo systems
  • Set boost by RPM and throttle, ground speed, or gear

Advanced Feature Set (Included!)

  • 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
  • Multiple traction control strategies
  • Built-in 3-step rev limiter / launch control with flat shift and burnout rev limiter
  • Time based timing / boost increase after launch
  • Real time barometric correction
  • Internal 4-bar MAP sensor reads up to 44PSI of boost
  • Overboost protection
  • Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
  • Rally style anti lag
  • Water injection control - on/off or variable
  • Knock sensor input with adjustable sensitivity, crank angle windowing, and more
  • Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
  • Input for flex fuel sensor - switch between E85 and gasoline on the fly!
  • CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless!

 

What you get in the box:

  • MegaSquirtPNP-Pro JS9298 ECU

  • USB tuning cable

  • Tuning Software and Documentation on USB memory stick

  • 6' Vacuum Hose for MAP Signal and 'T' fitting

  • Four Screws for ECU mounting

  • Registered version of TunerStudio and MegaLog viewer included

Our brands